Racine PSV 10 & 15 Variable Volume Pump

Racine PSV 10 & 15 Variable Volume Pump

Racine PSV 10 & 15 Variable Volume Pump

August 19, 2022 Comments Off

Manifold mounting RH rotation w/keyed shaft

* seal kit is for both sv10 & sv 15 this is included ** If you have the most common compensated/load sensing compensating pump you will have this screw to mount the first stage to the pump housing. There are other options for the compensator or controls, ask when ordering *** Not Available

#778364 has one pc. and #794468 has one pc. (1st block) (2nd block) *** shown other diagrams on this page

These kits have one rotor shaft, one key, one set of vanes, four roll pins, two port plates , two bearings, one pressure ring and one seal kit

On the measurement from the pump mounting flange to the center of the port, is lengthened by 3/8″ both types of pumps. The coupling system is a wet makeup. the lead pump don’t have a rear shaft sea. This will let the adapter to fill with fluid to grease and cool the coupling ** the weight of the railing pump goes over 65 lbs, you will need to use this part..roll pins have to pressed into the pump before you put it together

#17 is not provided in the whole assy.

this is a RH rotation, the 1st stage can’t be bought w/out the 2nd stage. *this is in the seal kit 778358 **not shown *** on the most common compensated/load sensing compensating pump the screw is sent to mount the 1st stage to the pump housing. All other options will need to be asked for when ordering. And don’t over toque the unit.

If you need further help with this unit, call us at 800-361-0068 or sales@htsrepair.com

About the author:

Susan Richardson