Denison Hydraulic Pump Barrel & Bearing Assy Part ll

Denison Hydraulic Pump Barrel & Bearing Assy Part ll

Denison Hydraulic Pump Barrel & Bearing Assy Part ll

Comments Off on Denison Hydraulic Pump Barrel & Bearing Assy Part ll

Denison Hydraulic Pump Barrel & Bearing Assy Part ll

In this part we will be talking about he bearing.

Put the inner race of the bearing (1) that have the seven tapped holes up, (making sure your barrel and all parts are clean). Pu the barrel assy (2) on the inner race with the ports turned up and the holes align up. The two screws 3″ long need to be used, put them in the two parts to use as a guide. Now press the barrel assy into the bearing inner race, then take out the screws you used as a guide.
Take the seven screws and put them into the barrel assy and thread into the bearing. Tighten all the screws evenly to 360 in lbs.
Take the two pins (4) and push them into the holes in the face of the barrel.
Rub or brush on a coat of oil on the face of the barrel and put in the face plate (5) over the pins and make sure the steel side is against the barrel.

If you need more info on this assembly, give us a call at 800-361-0068
email us at sales@hydrostatic-transmission.com

 

About the author:

Quick Links

  Home
  Services
  About
  Blog
  Store
  Contact

Social Links

Contact Information

  Address:
    1644 Eason Blvd
    Tupelo, MS 38801
  Toll Free: (800) 361-0068
  Local: +1 (662) 680-8899
  Email: info@hydrostatic-transmission.com

Back to Top