Denison Goldcup Model Series C & A Drive Shaft Installation

Series P6P, P6D, P6V – Model C

Series P7P, P7D, P7V – Model A

Installation Instruction

Put a retaining ring (3) over the internal end of the drive shaft (1) and put in the groove near the shaft seal surface.

Remember not to put it over seal surface.

Now glide the bearing (2) over the same end as before and make it sit up against the ring.

Making sure the inner race of the bearing is supported and push on the coupling end of the shaft.

Don’t put alot of force on the retaining ring, you don’t want to damage it.

Put in the other retaining ring (3) to the other retaining ring groove, making sure that both of the rings are in there all the way.

IF you need further instructions on this topic, please give us a call

800-361-0068

sales@hydrostatic-transmission.com