Sundstrand Sauer Danfoss Hydrostatic Parts & Repair
Sundstrand Sauer Danfoss Hydrostatic Parts & RepairMay 17, 2016 Comments Off on Sundstrand Sauer Danfoss Hydrostatic Parts & Repair
The most swash plate angle on model 33 pumps is 15.5°.
At the highest point of pressure it should not go beyond 1 % of operating time.
|Hydrostatic Transmission Service,LLC Offers Eaton Hydrostatic Parts and Eaton Hydrostatic Repair|
|Bi-metal bearing plate –offers steel for high speed and pressure, while bronze allows for greater bearing properties.
Valve plate- casehardened steel for extended life.
End cover- on Models 33 through 64 offers the fixed motors with huge passages that reduce losses on both side and rear ports.
C-pad rear mount- variable pumps for tandem units or for a through shaft are on Models 33 through 64.
Release valves- direct operated cartridge and fast acting direct types are on hand.
Controls- there are a wide selection of control options for pumps and motors to meet requirements.
Ports- SAE code 61 and code 62, along with o-ring boss ports are obtainable.
|Hydrostatic Transmission Service,LLC Offers EatonHydrostatic Parts and Eaton Hydrostatic Repair|
|Hydrostatic Transmission Service,LLC offers a selection of four charge pump displacements to go with the heavy duty transmission line: .85,1.28, 1.70, and 2.12 in3/rev [13,9; 21,0; 27,8; 34,7 cm3/rev]. These charge pumps are available with one or more of the following options:
a pressure sensing port
remote pressure side filter ports
a spin-on pressure side filter
mounting flanges for auxiliary pumps
|Charge Pump Ability|
If you need further assistance with this subject, please let us know.
Call us at 800-361-0068