Valve Drive for an EHD1
Valve Drive for an EHD1
September 1, 2023 Comments Off on Valve Drive for an EHD1
Electronic LVDT -null not much time needed for setup.
Dual Ramps – want have as much wear and tear on your hydraulic unit.
Deadband Compensation – gives off enough voltage to the bias for the mechanical overlay to the spool to the body.
Spool Travel Limits – lessens the actuator from running to long and helps with the speed to the control.
Diagnostic LED – reduce set up time and makes it easier to do troubleshooting.
Diagnostic Test Points – reduces set up on the board and makes it easier to troubleshoot.
Fault or Cable Break – gives it a safety circuit that will position itself in the center. * this is for temps that go above regular ranges for this specific unit.
This will give you selections for shutting of the power to the solenoids to avoid errors. It has a fault detection that visually displays the workings of the LVDT signal it puts out and its importance of the error signal in order to correct the problem. And it will stay lit up til the problem has been fixed.
This board is very easy and simply to setup and put up on mounts. Do not need any kind of special tool. Just give us a call about electrical board installation.
Call us at 800-361-0068
sales@htsrepair.com
Tags:
actuator avoid errors card holder circuit deadband compensation diagnostic LED Diagnostic test point dual ramps dual voltage electrical board electronic LVDT EX00-N50 EX00-S06 fault detection mode fault or cable break hydraulic hydrostatic LVDT signal machinery mechanical overlay power source power supply rebuild reduces setup reman repair screw terminals - no connector solenoids spool spool travel limits tractor transmission