John Deere 755B Crawler Park Brake Pedal Linkage and Valve Cable

To remove and install the pedal linkage:

Take off the handle (A) and the nut (B) from the lock rod (C).

The park brake pedal and support is taken out next.

You will need to disassemble part (D-I) from the support (J).

If any parts need to be repaired or even replace, do so now.

Then put back together parts (D-I) now to the support (J).

Put in the brake pedal and support.

The put in the lock rod (C) and nut (B) back into the handle (A).

A – handle                                                       F – spring

B – nut                                                             G – cotter pin

C – lock rod                                                    H – cotter pin

D – latch                                                          I – pin

E – washer                                                      J – support

Remove and install the park brake valve cable

Take out the center, front and right platforms.

You will need to disconnect cable (A) from the lever on the pedal shaft (C).

A – cable                                                                              G – cap screw (2 used)

B – lock nut                                                                         H – park brake valve to park

C- transmission pressure gauge line                                    brake element line

D – transmission operating pressure valve                   I – Park brake valve to

to park brake/ valve line                                                  reservoir line

E – park brake valve to transmission/drain line          J – pin

F – ball joint                                                                         K – manual brake disconnect

lever

picture below goes with the park brake valve instructions

If you have further questions, please let us know …

800-361-0068

sales@hydrostatic-transmisison.com