John Deere Crawler 755B – Service Recommendations on Metric Four Bolt Flange Fittings

John Deere Crawler 755B – Service Recommendations on Metric Four Bolt Flange Fittings

John Deere Crawler 755B – Service Recommendations on Metric Four Bolt Flange Fittings

Comments Off on John Deere Crawler 755B – Service Recommendations on Metric Four Bolt Flange Fittings

At our Hydrostatic Pump Repair Site, we offer many types of Hydrostatic Transmission Repair and information relating to Hydrostatic Parts
Today we will discuss:

John Deere Crawler 755B

Service Instructions for Metric Series Four Bolt Flange Fittings

You will need to clean all sealing surfaces (A). Look for any scratches or causes for leaks. Any coarseness will result in seal wear and extrusion, as well as out of flat will produce the same results. If you can’t polish out the problem, then it will need to be replaced.

Put in the right o ring (and backup washer if it needs it) into groove using petroleum jelly to make it stay in place.

Split Flange: Lightly put together the split flange halves (B). Making sure the the split is vertically and horizontally correct with each other. Hand tighten cap screws to keep the parts in place. Try not to pinch the O Ring (C).

Single piece flange (D): Put the hydraulic line in center of flange and put the four cap screws in. The flange needs to be centered on port. Hand tighten cap screws to keep the flange in place. The o ring ..try not to pinch it.

After all the components have been put in place and the screws have been tightened by hand, start tightening the screws one at a time. Tightening one then the one diagonally from the other, til they are all tightened. You may need to look at the chart below to help guide you on the torque you need to put on the screws.

Do not use an air wrench or over tighten the screws.

 

Torque Chart

Thread                                                        N-m                                         lb-ft

M6                                                                12                                               9

M8                                                               30                                               22

M10                                                             57                                                42

M12                                                             95                                                70

M14                                                            157                                               116

M16                                                            217                                               160

M18                                                            334                                              246

M20                                                            421                                              318

 

These are the recommended torques working pressure. Going beyond these torque values will result in the flange and cap screws bending and connection breakdowns.

If you need any questions answered on this topic, please let us know.

You can call us at 800-361-0068

Email: sales@hydrostatic-transmission.com

About the author:

Quick Links

  Home
  Services
  About
  Blog
  Store
  Contact

Social Links

Contact Information

  Address:
    1644 Eason Blvd
    Tupelo, MS 38801
  Toll Free: (800) 361-0068
  Local: +1 (662) 680-8899
  Email: info@hydrostatic-transmission.com

Back to Top